Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi !

Acoustic emission as tool wear monitoring (CROSBI ID 211438)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Duspara, Miroslav ; Sabo, Kristian ; Stoić, Antun Acoustic emission as tool wear monitoring // Tehnički vjesnik : znanstveno-stručni časopis tehničkih fakulteta Sveučilišta u Osijeku, 21 (2014), 5; 1097-1101

Podaci o odgovornosti

Duspara, Miroslav ; Sabo, Kristian ; Stoić, Antun

engleski

Acoustic emission as tool wear monitoring

This paper describes a fast Fourier transformation and its application to monitoring tool wear. Describes the transformation of the collected signal during cutting from the time domain to the frequency. The introduction describes the discrete Fourie transform, DFT deficiency observed in a large number of samples. Therefore, its use in this case is fast Fourie transform. As an example shown is an indirect method for monitoring tool wear that is based on the measurement values of process variables (acoustic emission) and the relationship between tool wear and these values. Tool wear monitoring is a difficult task because many machining processes are non- linear time-variant systems, which makes them difficult to model and the signals obtained from sensors are dependent on a number of other factors, such as machining conditions.

FFT; acoustic emission; tool wear; tool wear monitoring

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

21 (5)

2014.

1097-1101

objavljeno

1330-3651

Povezanost rada

Strojarstvo

Indeksiranost