Influence of Cutter Position on Cutting Forces and Tool Life in Face Milling (CROSBI ID 38210)
Prilog u knjizi | izvorni znanstveni rad
Podaci o odgovornosti
Kuljanić, Elso ; Sotino, Marco ; Totis, Giovanni
engleski
Influence of Cutter Position on Cutting Forces and Tool Life in Face Milling
In manufacturing industry there is a lack of information about the effect of relative transverse position between cutter and workpiece - centric or out of center face mailling - on tool life. In this work, the results of the investigation about the influence of the transverse position of face milling cutter on cutting forces, tool life and surface roughness are presented. Also, the experimental results obtained in this research were compared to data published in the literature.
milling, tool life, cutter position
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
nije evidentirano
Podaci o prilogu
169-180.
objavljeno
Podaci o knjizi
AMST'08 Advanced Manufacturing Systems and Technology
Kuljanić, Elso
Udine: CISM
2008.
978-88-85137-22-9