Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi

Effect of high temperature on properties of steel slag aggregate concrete (CROSBI ID 193219)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Netinger, Ivanka ; Varevac, Damir ; Bjegović, Dubravka ; Morić, Dragan Effect of high temperature on properties of steel slag aggregate concrete // Fire safety journal, 59 (2013), 1-7. doi: 10.1016/j.firesaf.2013.03.008

Podaci o odgovornosti

Netinger, Ivanka ; Varevac, Damir ; Bjegović, Dubravka ; Morić, Dragan

engleski

Effect of high temperature on properties of steel slag aggregate concrete

The use of slag as a fire-resistant aggregate was investigated in concrete and in structural members. Three mixtures of three-fractional concrete with type CEM I 52.5 N cement were prepared: the reference mixture (dolomite fractions of 0–4 mm, 4–8 mm and 8–16 mm) and two mixtures with coarse slag fractions (4–8 mm and 8–16 mm) and a fine dolomite fraction (0–4 mm). At 56 days the specimens were exposed to high temperatures. Their residual mechanical properties (flexural strength, compressive strength and static modulus of elasticity) and residual mass were tested after cooling, and results were compared among specimens. To determine the fire resistance of a structural member with slag in the concrete mixture, fire resistance of reinforced-concrete beams with slag was compared with that of reinforced-concrete beams with dolomite. In these experiments, concrete beams were exposed to high temperature according to the ISO 834 temperature curve for 60 min. The temperature increase within the beams during their exposure to high temperature in the furnace was also observed. Bearing capacity was tested after fire exposure and compared with bearing capacity of the beams at room temperature. The results showed that slag in combination with Portland cement did not increase fire resistance of concrete and its structural members. In order to create a structural member with improved fire resistance, slag should be combined with a binder that can better adapt to slag expansion under high temperature or be used as a partial replacement for coarse aggregate in concrete.

waste management; steel slag; aggregate; concrete; structural member; fire resistance

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

59

2013.

1-7

objavljeno

0379-7112

10.1016/j.firesaf.2013.03.008

Povezanost rada

Građevinarstvo

Poveznice
Indeksiranost