Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi

Photocatalytic activity of TiO2 thin films: kinetic and efficiency study (CROSBI ID 237361)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Grčić, Ivana ; Papić, Sanja ; Brnardić, Ivan Photocatalytic activity of TiO2 thin films: kinetic and efficiency study // International Journal of Chemical Reactor Engineering, 16 (2018), 1; 20160153, 19. doi: 10.1515/ijcre-2016-0153

Podaci o odgovornosti

Grčić, Ivana ; Papić, Sanja ; Brnardić, Ivan

engleski

Photocatalytic activity of TiO2 thin films: kinetic and efficiency study

The aim of this work was to evaluate the photocatalytic activity of two distinct anatase thin films. Films were prepared following the sol- gel procedure from titanium (IV) isopropoxide (TF- 1) and from commercial TiO2 P25 as a starting material (TF-2). The films were compared based on the salicylic acid (2- dihydroxybenzoic acid, 2- HBA) photocatalytic degradation in reactors of different geometry and under different irradiation conditions. Experiments were performed in (i) an annular photoreactors operated under turbulent flow (TAR1 and TAR2) and (ii) semi-annular reactor operated under laminar flow (LFR). The TF-1 and TF-2 were immobilized on the inner side of outer wall of TAR1 and TAR2 and on the bottom of LFR. Experimental study included sorption study and four consecutive photocatalytic runs (tirr = 8 hours) using TF-1 and TF-2 in each reactor. Obtained results confirmed the stability and the similar photocatalytic activity of the both films. The 2, 5-dihydroxybenzoic acid (2, 5- DHBA) and 2, 3-dihydroxybenzoic acid (2, 3-DHBA) were identified as main 2-HBA degradation by- products. Kinetic models were developed accordingly. Incident photon flux was determined along the inner reactor wall in annular reactors and on the bottom of LFR, i.e. on the thin film surface (Itf, W m-2) using ESSDE radiation emission model. The irradiation factor, i.e. the product of absorption coefficient and incident photon flux at film surface (μItf(z))m was introduced into the kinetic models. Resulting reaction rate constants ki (min- 1W-0.5 m1.5) were independent of reactor geometry, hydrodynamics, irradiation condition and the optical properties of thin films. Efficiencies of TF-1 and TF-2 in studied reactors were given on the basis of quantum yields (QY) for 2-HBA oxidation and overall mineralization toward CO2.

sol-gel ; TiO2 thin film ; salicylic acid ; degradation kinetics ; photocatalytic quantum yield

Glavni autori: Ivana Grčić, Ivan Brnardić

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

16 (1)

2018.

20160153

19

objavljeno

2194-5748

1542-6580

10.1515/ijcre-2016-0153

Povezanost rada

Interdisciplinarne tehničke znanosti, Kemija, Kemijsko inženjerstvo

Poveznice
Indeksiranost