Nalazite se na CroRIS probnoj okolini. Ovdje evidentirani podaci neće biti pohranjeni u Informacijskom sustavu znanosti RH. Ako je ovo greška, CroRIS produkcijskoj okolini moguće je pristupi putem poveznice www.croris.hr
izvor podataka: crosbi !

Numerical Analysis of Longitudinal Residual Stresses and Deflections in a T-joint Welded Structure Using a Local Preheating Technique (CROSBI ID 257958)

Prilog u časopisu | izvorni znanstveni rad | međunarodna recenzija

Perić, Mato ; Garašić, Ivica ; Nižetić, Sandro ; Dedić Jandrek, Hrvoje Numerical Analysis of Longitudinal Residual Stresses and Deflections in a T-joint Welded Structure Using a Local Preheating Technique // Energies (Basel), 11 (2018), 12; 1-13. doi: 10.3390/en11123487

Podaci o odgovornosti

Perić, Mato ; Garašić, Ivica ; Nižetić, Sandro ; Dedić Jandrek, Hrvoje

engleski

Numerical Analysis of Longitudinal Residual Stresses and Deflections in a T-joint Welded Structure Using a Local Preheating Technique

In this paper a numerical analysis of a T-joint fillet weld is performed to investigate the influences of different preheat temperatures and the interpass time on the longitudinal residual stress fields and structure deflections. In the frame of the numerical investigations, two thermo-mechanical finite element models, denoted M2 and M3, were analyzed and the results obtained were then compared with the model M1, where the preheating technique was not applied. It is concluded that by applying the preheat temperature prior to the start of welding the post-welding deformations of welded structures can be significantly reduced. The increase of the preheat temperature increased the longitudinal residual stress field at the ends of the plates. The influence of the interpass time between two weld passes on the longitudinal residual stress state and plate deflection was investigated on two preheated numerical models, M4 and M5, with an interpass time of 60 s and 120 s, respectively. The results obtained were then compared with the preheated model M3, where there was no time gap between the two weld passes. It can be concluded that with the increase of interpass time, the plate deflections significantly increase, while the influence of the interpass time on the longitudinal residual stress field can be neglected.

welding residual stress ; welding deflection ; T-joint fillet weld ; preheat temperature ; interpass time ; finite element analysis

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

nije evidentirano

Podaci o izdanju

11 (12)

2018.

1-13

objavljeno

1996-1073

10.3390/en11123487

Trošak objave rada u otvorenom pristupu

Povezanost rada

Strojarstvo, Temeljne tehničke znanosti

Poveznice
Indeksiranost